KAJIAN PERBANDINGAN TARIF SEWA ALAT BERAT BERDASARKAN PERDA KABUPATEN KERINCI NO. 23 TAHUN 2011 TENTANG BIAYA SEWA ALAT BERAT DENGAN SEWA PIHAK SWASTA
Abstract
The problems that arise from the current rate implications are also unfavorable for thegovernment because contractors are more likely to hire the tools provided by the private
sector, the reality tool rental rates imposed by the private sector is much higher than the
rental rates of government. The result of the calculation calculations PAD Kerinci derived
from the rental of heavy equipment in the year 2012 until 2014 seen a sharp decline an
average of 35.23% annually although in 2015 there was a slight rise, but not quite as sharp
as the reception in 2012. The results of the identification An initial look that the basic rate
applied by the private sector accompanied by providing skilled operator and machine
conditions in a state of sufficient so that the possibility of working hours lost or
unproductive can be suppressed properly and effectively. Starting from this problem, the
study is intended to determine the factors that influence the differences between the heavy
equipment rental rates Kabupaten Kerinci Regulation No. 23, 2011 with the rental rate of
the private sector and at the same time determine the feasibility of heavy equipment rental
rates of by Kerinci District Regulation No. 23 of 2011 which is based on the working
capacity of the tool. Based on calculations and analysis using a variety of approaches, the
obtained results that the heavy equipment rental rates are specified in Kerinci District
Regulation No. 23 in 2011 was not in accordance with the working capacity of the tool and
is relatively lower than the rental rates that the other party (private). This difference is
caused by several dimensions of the condition and performance of the tool when used with
and the recency of the condition of the tool is based on the residual value when the tool is
used.
Keywords: Heavy Equipment, Regional Original Revenue
References
Darmansyah Nabar, (1998). Alat
Beratuntuk Proyek Konstruksi,
Rineka Cipta, Jakarta.
Dj. A. Simarmata (1984), Pendekatan
Sistem Dalam Analisa Proyek
Investasi Dan Pasar Modal, Gramedia,
Jakarta
Djoko Wilopo (2006), Metoda Konstruksi
dan Alat-Alat Berat, Universitas
Indonesia, Jakarta
I Nyoman Pujawan (1995), Ekonomi
Teknik, PT. Guna Widya, Jakarta.
Mason, R.D & Douglas A. Lind. (1996).
Teknik Statistik Untuk Bisnis dan
Ekonomi. Penerbit Erlangga, Jakarta.
Rochmanhadi (1999), Kapasitasdan
Produksi Alat-Alat Berat,
BadanPenerbitPekerjaanUmum, Jakarta
Sastraatmaja, A.S. (1984), Analisa (Cara
Modern) Anggaran Biaya
Pelaksanaan, Nova, Bandung.
Soeharto, Iman (1998), Manajemen Proyek,
Edisi Kedua, Erlangga, Jakarta.
Suratman, (2001). Studi Kelayakan Proyek,
J & J Learning, Yogyakarta.
Kodoatie (1994), Analisa Ekonomi Teknik,
Andi Ofset, Yogyakarta.
Yutiar M Yost (2007), Pemilihan Pemakaian
Alat Berat Berdasarkan Produksi
Alat, Padang